Classic cars forum & vehicle restoration.
|
Author |
Message |
Richard H
Joined: 03 Apr 2009 Posts: 2148 Location: Lincolnshire, UK
|
Posted: Thu Oct 07, 2010 10:23 am Post subject: 1958 Austin A55 Cambridge MK1 Restoration |
|
|
I bought this at the beginning of August, it had a very short MOT but was cheap. Maybe I should have suspected something? Anyway it was very local, drove nicely with a good recon engine and positive column gearchange, the interior had obviously been retrimmed to a good standard at some point and it was just generally a nice old car. So I put in my bid on Ebay, and won it!
After getting it home, the first problem was the brakes pulled sharply to the left. Further investigation revealed five out of six wheel cylinders were leaking and the (new) shoes were badly contaminated. A phone call to Earlpart and a considerably lighter wallet later and I had new wheel cylinders and shoes all round. We then attempted to bleed the brakes, which blew out the seals on the master cylinder. A new master was swiftly purchased from Ebay:
Once all this was sorted out, it was time to turn our attentions to the other MOT items. The wipers were next to useless, so new arms and blades were ordered from Earlpart, the horn not working was eventually traced to some bodged wiring, and the welding...well I'll let the pics do the talking...
This car had obviously been stored outside for a very long time, which had taken its toll. A lot of the welding that was already there looked half decent at first glance, unfortunately it had all been welded over the rust, so most of it had to come out and we started again from scratch.
Started T-cutting and polishing the very faded paint:
Note the new grille, a very lucky Ebay find.
And taken today
It shares the conservatory with this:
and this:
Hope you like it!
Last edited by Richard H on Fri Mar 08, 2013 8:30 pm; edited 3 times in total |
|
Back to top |
|
|
Rick Site Admin
Joined: 27 Apr 2005 Posts: 22437 Location: UK
|
|
Back to top |
|
|
Richard H
Joined: 03 Apr 2009 Posts: 2148 Location: Lincolnshire, UK
|
Posted: Thu Oct 07, 2010 11:19 am Post subject: |
|
|
Thanks Rick. It's coming along nicely, although there's still a fair bit to do.
Both front wings are completely rotten, although surprisingly the vulnerable rear wings are like new. Anyway front wings are as rare as hens teeth, a new fibreglass one for the drivers side came with the car so I will buy a matching one for the passenger side and these will then be fitted. There's also some rot in the passenger door to sort out, and at least a partial respray as the paint (on the roof in particular) is very crazed indeed. |
|
Back to top |
|
|
bob2
Joined: 06 Dec 2007 Posts: 1727 Location: Malta
|
Posted: Fri Oct 08, 2010 8:01 am Post subject: |
|
|
already looks a million times better though, well done Richard!! |
|
Back to top |
|
|
Richard H
Joined: 03 Apr 2009 Posts: 2148 Location: Lincolnshire, UK
|
Posted: Mon Nov 22, 2010 8:50 pm Post subject: |
|
|
Well I've just started using the A55 as my daily, and so far it's been great
One job that needed doing before the winter was sorting out the heater, it had never worked and I realised the matrix must be clogged
Unfortunately on these cars it's hidden away right up behind the dashboard and is totally inaccessible, I managed to get the hose pipe on and loads of muck came out, but still no heat would come through.
Luckily my dad had a brainwave, an old rusty Morris Minor heater from the depths of the garage, past experience has told us these are amazingly powerful and streets ahead of the 1950's Austin heaters. So a few coats of some 2CV Custard aerosol paint to match the dashboard, some rerouted pipes and wires and a bit of "dymotape" and I now have a half decent heater!
I think it looks rather neat. My dad also cut out all the rot from the top of the O/S front wing and welded in a huge repair section roughly 1' square, cheers dad!
Glistening in the garage. The stuff all over the front of the car is mud, but not due to my driving, it was a filthy truck coming the other way
I'm driving it up to Great Yarmouth tomorrow to collect a new exhaust for my A35 before I sell it (the A35), great car, anyone interested? |
|
Back to top |
|
|
Richard H
Joined: 03 Apr 2009 Posts: 2148 Location: Lincolnshire, UK
|
Posted: Tue Nov 23, 2010 11:11 pm Post subject: |
|
|
I brim-filled the tank before I left for Norkolk, drove there and back and got out of the garage and to the end of the road before it ran out of petrol (showing 1/4 on the gauge, I'll have to watch that one). Luckily I had a gallon of petrol in the boot so I sloshed that in, when I got to the petrol station it cost me £47 to fill up the car and my can. Seems expensive after the frugal little A35. Time for some calculations, 275 miles covered on a tank of petrol makes for roughly 31 mpg, which isn't too bad at all especially considering I wasn't hanging around and much of the journey was completed at 60-70mph, I think the Audi and Merc drivers must have been very surprised to see an old Cambridge zooming past them in the fast lane! |
|
Back to top |
|
|
Nic Jarman
Joined: 05 Oct 2008 Posts: 1031 Location: Stoke by Clare, Suffolk
|
Posted: Wed Nov 24, 2010 12:41 am Post subject: |
|
|
I quite like the older Cambridges. Were they made in any other colour than black? _________________ 1936 Morris 8 Series 1
1973 MGB roadster
1977 MG Midget 1500
Dax Rush |
|
Back to top |
|
|
Richard H
Joined: 03 Apr 2009 Posts: 2148 Location: Lincolnshire, UK
|
Posted: Wed Nov 24, 2010 12:58 am Post subject: |
|
|
Grey? |
|
Back to top |
|
|
Nic Jarman
Joined: 05 Oct 2008 Posts: 1031 Location: Stoke by Clare, Suffolk
|
Posted: Wed Nov 24, 2010 1:19 am Post subject: |
|
|
Class _________________ 1936 Morris 8 Series 1
1973 MGB roadster
1977 MG Midget 1500
Dax Rush |
|
Back to top |
|
|
Richard H
Joined: 03 Apr 2009 Posts: 2148 Location: Lincolnshire, UK
|
Posted: Tue Dec 21, 2010 5:43 pm Post subject: |
|
|
Not really an update, but the Cambridge started first time yesterday morning in -6 temperatures and all covered in ice! It ticked over nicely and half way to work I was getting toasty warm with the new heater. Unfortunately I snapped the rear exhaust mount on a speedbump (I wasn't driving too fast honest officer) so the exhaust is knocking on the floor at idle, but that can wait until the weather gets warmer as it's just too cold to be working on cars outside at the moment |
|
Back to top |
|
|
Bellisin
Joined: 19 Dec 2010 Posts: 16
|
Posted: Tue Dec 28, 2010 5:51 pm Post subject: |
|
|
The Cambridge looks great and that welding looks as neat as mine
What I am most impressed with is the fact you seem to have build a double glazed conservatory for you cars? Now that is love!
Stuart |
|
Back to top |
|
|
Richard H
Joined: 03 Apr 2009 Posts: 2148 Location: Lincolnshire, UK
|
Posted: Thu Jan 13, 2011 3:43 pm Post subject: |
|
|
_________________ Richard Hughes |
|
Back to top |
|
|
peter scott
Joined: 18 Dec 2007 Posts: 7117 Location: Edinburgh
|
|
Back to top |
|
|
FrazzleTC
Joined: 28 Dec 2010 Posts: 146 Location: Dumfries and Galloway
|
Posted: Thu Jan 13, 2011 8:07 pm Post subject: |
|
|
Sorry to see that you had to have the car recovered, my car went through a phase of spending time on the back of recovery vehicles which has since stopped, thankfully. It looks a very nice car indeed. What was the problem? |
|
Back to top |
|
|
Rick Site Admin
Joined: 27 Apr 2005 Posts: 22437 Location: UK
|
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
php BB powered © php BB Grp.
|